Snapon ratchet dating gag gifts dating teenage girls

Snap-on Tools is one of the largest and best known makers of hand tools today.

This article will look at the development of the company during the 1920s, covering its first ten years of operations.

(The size marking was usually on the opposite side from the S/O-Overstrike.) This marking style was used up until about 1923.

Around 1924 Snap-On began marking sockets with their full logo instead of the S/O-overstrike.

The Snap-On Wrench Company was founded in 1920 by Joseph Johnson and William Seidemann, with its initial location at 134 Reed Street in Milwaukee, Wisconsin.

The company's founding principle was the superiority of interchangeable socket tools over fixed (or "tight") socket wrenches, and their first product was a modest collection of five drive handles and ten sockets.

Additional drive sizes were offered later, 5/8-drive in 1923, 7/8-drive around 1924, 9/32-drive in 1925, and finally 3/8-drive in 1928.

A similar notice (but without the display board illustration) was published on page 64 of the February 15, 1921 issue of the The table below lists the various trademarks filed by the Snap-On Wrench Company (or its Blue Point subsidiary) during the 1920s.

The entries are presented in order of the registration number.

Snap-On also introduced a socket numbering system at about the same time, which consisted of the abbreviation "NO." followed by the model number, a variation on the size expressed in 32nds.

For example, a 1/2-drive 6-point socket of size 7/8 was marked "NO. Sockets marked in this fashion will have the model number, Snap-On logo, and fractional size, all on the same side of the socket.

Leave a Reply